Digital services CLM 50-H050-ASP
Technical data CLM 50-H050-ASP
|extend force [N]||120|
|retracted force [N]||103|
|Repeat accuracy [mm]||0.02|
|Piston diameter [mm]||16|
|Bar diameter [mm]||6|
|Min. operating pressure [bar]||3|
|Max. operating pressure [bar]||8|
|Nominal operating pressure [bar]||6|
|Fluid consumption/10 mm stroke [cm³]||2|
|Overall length [mm]||156|
|IP protection class||40|
|Min. ambient temperature [°C]||5|
|Max. ambient temperature [°C]||60|
|Drive concept||Piston rod cylinders|
|Length X [mm]||166|
|Width Y [mm]||52|
|Height Z [mm]||45|
|Moment Mx max. [Nm]||17|
|Moment My max. [Nm]||15.1|
|Moment Mz max. [Nm]||7.55|
|Clearance N (for moment load) [mm]||34|
|Max. axial force Fz max. [N]||372|
|Version with holding brake||yes|
General notes about the series
is defined as a distribution of the end positions for 100 consecutive cycles.
are pure movement times of the slide or the base body. Valve switching times, hose filling times, or PLC reaction times are not a part of this and are to be considered when cycle times are calculated.
is the maximum nominal stroke of the unit. It can be shortened on both sides by the shock absorbers.
Layout or control calculation
For configuration or control calculation of the units, we recommend to use our Toolbox software, which is available online. Verifying the sizing of the selected unit is absolutely necessary, as otherwise overloading may occur.
The modules are mainly designed for the use in clean ambient conditions. Please note that the life time of the modules can shorten if they are used in harsh ambient conditions, and that SCHUNK cannot assume liability in such cases. Please contact us for assistance.
Aluminum alloy, anodized
Backlash-free, pre-loaded cross roller guide
pneumatic, with filtered compressed air as per ISO 8573-1:2010 [7:4:4].
Scope of delivery
incl. shock absorbers respectively stop screws (CLM 08)
Service life characteristics