arrow calendar cartcheck checkmark close configure contact danger download external_link facebook globeinfo instagram linkedin logo_claim logout mail menuminus navigation pin play plus rss searchshaft success twitteruserwarning wechat x-twitterxing youku youtube zoom
Change the country selection to see information on the products, services and contact persons that are relevant for your location.
ROTA NCML

ROTA NCML

Hybrid chuck with manual workpiece centering
Hybrid chuck, which combines the advantages of centering via a 3-jaw manual lathe chuck and deformation-free clamping of the magnetic clamping technology of all ferromagnetic components.

Advantages – Your benefits

  • Workpiece centering via manual 3-jaw wedge bar chuck
    No manual alignment of the workpiece is necessary
  • Deformation-free magnetic workpiece clamping
    For maximum radial and axial run-out tolerances
  • High magnetic holding forces
    Depending on the workpiece geometry and material, a high cutting performance is possible
  • For internal and external centering
    For universal and flexible use
  • Optimum dirt sealing, encapsulated centering chuck
    Low maintenance costs and high clamping precision ensured
  • Standard interface for centering jaws
    Centering jaws can be manufactured from SCHUNK standard jaws
  • High clamping force due to jaw support
    Higher cutting performance, particularly during hard turning
  • For grinding and hard turning
    Ideal for high-precision workpiece machining
  • For horizontal and vertical machines
    Suitable for use with almost every machine tool (turning – milling – grinding)
  • 3-sided machining possible due to retractable jaws
    Reduced set-up costs, shorter processing times

Options and special information

  • Low-deformation clamping of rings and fitting disks
    The ROTA NCML is a combination of manual lathe chuck and magnetic clamping chuck. The manual lathe chuck serves to center the workpiece on the chuck and then clamps it via the magnetic clamping chuck without deformation and vibration. Double AlNiCo magnets are integrated in the magnetic chuck, which allow for demagnetization of the workpiece after machining.
  • The hybrid chuck is controlled via a control unit or directly via the machine control system. The workpiece can also be lifted from the chuck using pole extensions, and then milled from three sides.