CGP
Function
Funktionsschnittbild
Funktionsschnittbild
Der Kolben wird über Druckluft nach oben bzw. unten bewegt.
Die schrägen Wirkflächen des Keilhakens erzeugen dabei eine synchrone parallele Backenbewegung.
- 1
-
T-Nuten-Gleitführung
belastbare, widerstandsfähige Grundbackenführung für große Fingerlängen - 2
-
Grundbacke
mit standardisiertem Anschraubbild zur Adaption der werkstückspezifischen Greiferfinger - 3
-
Gehäuse
ist gewichtsoptimiert durch Verwendung einer hochfesten Aluminiumlegierung - 4
-
Keilhakenprinzip
für hohe Kraftübertragung und niedrigsten Verschleiß durch größere Schrägzugfläche - 5
-
Pneumatischer Antriebskolben
Zur Erzeugung der Greifkraft
Gripping force maintenance version AS/IS
Position monitoring via magnetic switch
Position monitoring using inductive proximity switches
그리퍼 어셈블리를 위한 센터링 및 장착 옵션
전원 공급 장치을 위한 공압 연결
Gripping force maintenance version AS/IS
The mechanical gripping force maintenance device ensures that a minimum clamping force will be applied even if there is a drop in pressure. In the AS version this acts as a closing force, and in the IS version as an opening force. The image shows the AS version. The gripping force maintenance can also be used to increase the gripping force or for one-way gripping.
- 1
-
T-slot guidance
- 2
-
Base jaw
- 3
-
Housing
- 4
-
Wedge-hook design
- 5
-
Piston
- 6
-
Gripping force maintenance by means of a pressure spring
Position monitoring via magnetic switch
For monitoring with magnetic switches, the gripper is equipped with two sensor slots. The image shows the "gripper open" and "gripper closed" position query with two MMS 22 sensors.
Position monitoring using inductive proximity switches
The gripper variant "-IN" is prepared for monitoring with two inductive proximity switches. The positions "gripper open" and "gripper closed" are preset. Proximity switches must be ordered separately and are inserted to the stop and clamped. Both switching points can be set individually to monitor any other position such as "workpiece gripped" for example.
그리퍼 어셈블리를 위한 센터링 및 장착 옵션
그리퍼는 두 방향의 나사를 이용해 장착할 수 있습니다.
전원 공급 장치을 위한 공압 연결
그리퍼는 양쪽 면에 압축 공기를 유연하게 공급하는 것이 가능합니다.
- 1
-
공기 피팅 및 공압 호스를 사용하여 메인 공기 연결부 A 및 B를 통해 전면부에서.
- 2
-
하단에서 직접 연결을 통하거나 b를 통해 튜브리스 직접 연결 및 제공된 O-링 사용. 공압 공급은 어댑터 플레이트를 통해 제공됩니다.
적용 예시
적용 예시
트레이에서 14개의 부품을 동시에 제거할 수 있도록, 여러 개의 단일 그리퍼로 구성된 다중 그리퍼 유닛.
- 1
-
CGP 2조 평행 그리퍼