arrow calendar cartcheck checkmark close configure contact danger download external_link facebook globeinfo instagram linkedin logo_claim logout mail menuminus navigation pin play plus rss searchshaft success twitteruserwarning wechat x-twitterxing youku youtube zoom
Change the country selection to see information on the products, services and contact persons that are relevant for your location.
KSX-C2

KSX-C2

5-axis vise
5-axis vise with adjustable clamping center, largest basic clamping stroke and active jaw pull-down function for the complete and precise machining of the sixth side.

Advantages – Your benefits

  • Active jaw pull-down
    Optionally allows complete and precise machining of the sixth side
  • Jaw quick-change without any tools
    Adjustment to new clamping tasks within seconds
  • Adjustable clamping center
    Small and large workpieces are always clamped centrically
  • Long basic clamping stroke with 130 mm
    Wide range of applications without additional extensions
  • Extendable clamping range
    Enables clamping of various workpiece lengths
  • Optimal accessibility
    Allows the workpiece to be machined from five sides
  • Integrated elastomer damping
    To minimize vibrations during machining
  • Wide range of applications
    Suitable for rough and finished parts machining
  • Vast chuck jaw program
    Optimal adaptation to new clamping tasks
  • Clamping by tension
    No bending of base body
  • VERO-S interface
    Can be flexibly combinationed with the large VERO-S modular system. Even shorter set-up times

Options and special information

  • The 5-axis vise for 6-sided machining
    The single-acting vise KONTEC KSX-C2 combines several unparalleled features for 5-axis machining. An adjustable clamping center, optimum accessibility to the workpiece and the basic clamping stroke of 130 mm make the KSX-C2 an incredibly versatile clamping device. The absolute highlight is the active pull-down function of the vise integrated by default. This is done by locking the second jaw and allows a complete and precise machining of the sixth side without conversion to other dimensions.
  • A new jaw quick-change system enables the exchange of a large number of system jaws with each other within a few seconds and completely without tools. In combination with drawbar extensions, the KSX-C2 can be quickly and easily adapted to any new requirement. Due to the integrated VERO-S interface, clamping pins can be directly screwed into the base body, and the 5-axis vise can be located on the quick-change pallet system.