LDM-EL-0400
- Max. stroke: 2600 mm
- Max. driving force: 1000 N
Technical details
| Drive concept | Linear direct drive |
|---|---|
| Max. stroke H [mm] | 2600.0 |
| Max. driving force [N] | 1000.0 |
| Nominal force [N] | 370.0 |
| Max. payload (horizontal) [kg] | 40.0 |
| Repeat accuracy [mm] | ± 0.01 |
| Max. speed [m/s] | 4.0 |
| Max. acceleration [m/s²] | 40.0 |
| Max. current [A] | 28.0 |
| Max. standstill current [A] | 6.73 |
| Min. ambient temperature [°C] | 5.0 |
| Max. ambient temperature [°C] | 40.0 |
| Weight slide and motor [kg] | 10.17 |
| Weight of end plates [kg] | 1.45 |
| Additional mass per 100 mm stroke [kg] | 1.16 |
| Length X [mm] | 350.0 |
| Width Y [mm] | 174.0 |
| Height Z [mm] | 112.0 |
| Moment Mx max. [Nm] | 1399.0 |
| Moment My max. [Nm] | 2576.0 |
| Moment Mz max. [Nm] | 2576.0 |
| Force Fy max. [N] | 22800.0 |
| Force Fz max. [N] | 45600.0 |
| Force -Fz max. [N] | 22800.0 |
| Length A [mm] | 290.0 |
| Length L [mm] | 350.0 |
| Length L1 [mm] | 320.0 |
| Length L2 [mm] | 175.0 |
Dimensions and maximum loads
Dimensions and maximum loads
The forces and torques shown here are maximum values for static loading.
General notes about the series
Repeat accuracy
defined as the spread of the target position after 100 consecutive positioning cycles under constant conditions.
Ambient conditions
The modules are mainly designed for the use in clean ambient conditions. Please note that the life time of the modules can shorten if they are used in harsh ambient conditions, and that SCHUNK cannot assume liability in such cases. Please contact us for assistance.
Layout or control calculation
Verifying the sizing of the selected unit is necessary, since otherwise overloading can result. Please contact us for assistance.
Guidance
Roller guide
Drive
Linear direct drive based on a 3-phase, electronically commutated and permanently excited AC synchronous liner motor
Stroke measuring system
Contactless, magnetic measuring system with incremental and absolute variants; with HIPERFACE®, 1Vss and DRIVE-CLiQ interfaces.
Profile
Aluminum press-drawn section with ground steel guide strips
Slide
Aluminum slide, primary part and measuring system reading head directly integrated
Scope of delivery
Accessory pack with centering sleeves and assembly and operating manual with declaration of incorporation
Drive controller
Bosch Rexroth IndraDrive and Siemens SINAMICS drive control units supported as standard; matching parameters supplied on DVD, other manufacturers available on request.
Warranty
24 months
Service life characteristics
on request