RM 12-H-RZ
ID 313013
Produits alternatifs :
- Couple: 0.38 Nm
Détails techniques
| Angle de rotation [°] | 190 |
|---|---|
| Réglage des fins de course [°] | 90 |
| Couple [Nm] | 0.38 |
| Nombre de positions intermédiaires | 1x M (Position intermédiaire pneumatique) |
| Réglage position intermédiaire [°] | 190.0 |
| Indice de protection IP | 40 |
| Poids [kg] | 0.48 |
| Consommation de fluide (2x angle nominal) [cm³] | 4.8 |
| Pression d'utilisation nominale [bar] | 6.0 |
| Pression d'utilisation min. [bar] | 3.0 |
| Pression d'utilisation maximale [bar] | 8.0 |
| Température ambiante mini. [°C] | 5.0 |
| Température ambiant maxi. [°C] | 60.0 |
| Inertie max. autorisée de la configuration | 4.5E-4 |
| Répétabilité [°] | 0.15 |
| Répétabilité (différence entre les deux sens) [°] | 0.35 |
| Longueur X [mm] | 122.0 |
| Largeur Y [mm] | 43.0 |
| Hauteur Z [mm] | 35.0 |
| Moment My max. [Nm] | 5.0 |
| Force axiale max. Fz max. [N] | 590.0 |
Dimensions et charges max.
Moment d'inertie admissible max. J*
Dimensions et charges max.
Les moments et les forces indiqués correspondent à des valeurs statiques et peuvent survenir simultanément. Le réglage de la vitesse par les limiteurs de débit doit être effectué pour s'assurer que le mouvement de rotation est réalisé sans impact ni rebond. Dans le cas contraire, la durée de vie peut être réduite.
Moment d'inertie admissible max. J*
- Axe X:
- Temps de rotation
- Axe Y:
- Moment d'inertie de masse
- Axe X supérieur:
- Cycles par heure
General notes about the series
Repeat accuracy
is defined as a distribution of the end position for 100 consecutive cycles.
Pinion position
is always shown in the left end position. The pinion rotates from here to the right in clockwise direction. The arrow makes the direction of rotation clear.
Pinion screw connection diagram
When setting a swivel angle smaller than 90°, the left end stop must be completely turned in. This means that the left end position has a screw connection diagram on the pinion which is clockwise turned by 90° compared to the main view, which shows a swivel angle of 180°.
Layout or control calculation
For configuration or control calculation of the units, we recommend to use our Toolbox software, which is available online. Verifying the sizing of the selected unit is absolutely necessary, as otherwise overloading may occur.
Housing material
Aluminum alloy, anodized
Actuation
pneumatic, with filtered compressed air as per ISO 8573-1:2010 [7:4:4].
Operating principle
Double piston rack and pinion principle
Scope of delivery
Completely ready for operation without bracket for proximity switch and without proximity switch
Warranty
24 months