SGW 64
ID 305206
- Opening angle: 8 °
- Closing moment: 7.45 Nm
- Max. ambient temperature: 90 °C
Technical details
| Closing force (with finger lengths of 0 mm) [N] | 1218.0 |
|---|---|
| Opening angle per jaw [°] | 8.0 |
| Closed angle per jaw up to [°] | 2.0 |
| Closing moment [Nm] | 7.45 |
| Weight [kg] | 0.17 |
| Recommended workpiece weight [kg] | 1.3 |
| Cylinder volume per double stroke [cm³] | 1.8 |
| Min. operating pressure [bar] | 4.0 |
| Max. operating pressure [bar] | 7.0 |
| Nominal operating pressure [bar] | 6.0 |
| Closing time [s] | 0.02 |
| Opening time [s] | 0.03 |
| Max. permissible finger length [mm] | 50.0 |
| Max. permissible weight per finger [kg] | 0.07 |
| IP protection class | 20 |
| Min. ambient temperature [°C] | 5.0 |
| Max. ambient temperature [°C] | 90.0 |
| Repeat accuracy [mm] | 0.1 |
| Diameter D [mm] | 64.0 |
| Height Z [mm] | 44.0 |
| Moment Mx max. [Nm] | 0.4 |
| Moment Mz max. [Nm] | 0.3 |
| Max. axial force Fz max. [N] | 8.0 |
Dimensions and maximum loads
Gripping force O.D. gripping
Closing moment curve
Dimensions and maximum loads
The indicated torques and forces are static values, apply for each base jaw, and may occur simultaneously.
Gripping force O.D. gripping
- X-axis:
- Point P - Finger length
- Y-axis:
- Gripping force
Closing moment curve
- X-axis:
- Opening angle
- Y-axis:
- Closing moment
General notes about the series
Closing moment
is the arithmetic sum of the individual moment applied to each jaw.
Finger length
is measured from the reference surface as the distance P in direction to the main axis.
Repeat accuracy
is defined as a distribution of the end Position for 100 consecutive strokes.
Workpiece weight
is calculated for force-fit gripping with a coefficient of static friction of 0.1 and a safety factor of 2 against workpiece slippage at acceleration due to gravity g. For form-fit or capture gripping, there are significantly higher permissible workpiece weights.
Closing and opening times
are movement times of the base jaws only, without application-specific gripper fingers. Valve switching times, hose fill times, or PLC reaction times are not included, and are to be considered when cycle times are calculated.
Werkingsprincipe
in één richting werkende 3-voudige zuiger met tandwieloverbrenging via hefboom en herpositionering door veer
Materiaal behuizing
Kunststof met metalen functiecomponenten
Materiaal basisklem
Kunststof
Aandrijving
pneumatisch, met gefilterde perslucht conform ISO 8573-1:2010 [7:4:4].
Garantie
24 maanden
Kenmerken levensduur
op verzoek
Levering
Centreerstiften, O-ringen voor directe aansluiting, montage-instructies (gebruikershandleiding met inbouwverklaring is online beschikbaar)
Behoud van grijpkracht
niet mogelijk