DRL 25-W090-ASP
ID 314771
- 수직 스트로크[Z축]: 40 mm
- 회전 각도: 90 °
- 최대 탑재량: 3 kg
기술 세부 정보
| 회전 각도 [°] | 90 |
|---|---|
| 측면당 각 설정 [°] | 2.0 |
| 수직 스트로크[Z축] [mm] | 40.0 |
| 스트로크 수직 리니어 [Z축] [mm] | 20.0 |
| 면당 수직 스트로크 조정[Z축] [mm] | 10.0 |
| 말단 위치 사이 높이의 최대 차이 [mm] | 10.0 |
| 토크 [Nm] | 3.7 |
| 포스 인상 [N] | 321.0 |
| 포스 설정 [N] | 298.0 |
| 반복 정밀도[Z축] [mm] | ± 0.01 |
| 반복 정확도, 회전 [°] | 0.02 |
| 최소 작동 압력 [bar] | 3.0 |
| 최대 작동 압력 [bar] | 5.0 |
| 정격 가동 압력 [bar] | 5.0 |
| 사이클당 실린더 용량 [cm³] | 176.0 |
| 최소 주위 온도 [°C] | 5.0 |
| 최대 주위 온도 [°C] | 60.0 |
| 최대 탑재량 [kg] | 3.0 |
| 분당 최대 허용 사이클 시간 [1/min] | 63.0 |
| 중량 [kg] | 5.0 |
| 정지 유지 브레이크가 있는 버전 | 예 |
Max. loads
사이클 시간
사이클 시간
Max. loads
No further loads above and beyond the loads due to handing the structure may arise.
사이클 시간
- X축:
- 사이클 시간
- Y축:
- 관성의 질량 모멘트
사이클 시간
- X축:
- 사이클 시간
- Y축:
- 질량
General notes about the series
Repeat accuracy
Is defined as the spread of the target position after 100 consecutive positioning cycles.
Cycle times
The cycle times refer to a typical pick & place movement of the lift/turning unit. Please note that the actual cycle time is influenced by the hose length and/or hose diameter and valve switching or PLC response times.
Stroke
The stroke is the maximum nominal stroke per axis direction. It can be shortened for each side.
Ambient conditions
The modules are mainly designed for the use in clean ambient conditions. Please note that the life time of the modules can shorten if they are used in harsh ambient conditions, and that SCHUNK cannot assume liability in such cases. Please contact us for assistance.
Nominal load or mass moment of inertia
The values refer to the total load attached to the flange. Please note that the life time of the modules is shortened if the maximum values are exceeded and that SCHUNK cannot provide any warranty in such cases.