LM 300-H125-ASP
ID 314488
- 最大行程: 125 mm
Détails techniques
| 行程 [mm] | 125.0 |
|---|---|
| 伸出力 [N] | 753.0 |
| 缩回力 [N] | 633.0 |
| 重复精度 [mm] | 0.02 |
| 活塞直径 [mm] | 40.0 |
| 杆直径 [mm] | 16.0 |
| 最小工作压力 [bar] | 3.0 |
| 最大工作压力 [bar] | 8.0 |
| 额定工作压力 [bar] | 6.0 |
| 每双行程的气缸容量/10 mm [cm³] | 12.57 |
| 总长度 [mm] | 424.0 |
| IP 防护等级 | 40 |
| 最低环境温度 [°C] | 5.0 |
| 最高环境温度 [°C] | 60.0 |
| 洁净室等级 14644-1:1999 | 6 |
| 重量 [kg] | 7.71 |
| 传动概念 | 气缸活塞杆 |
| 长度 X [mm] | 424.0 |
| 宽度 Y [mm] | 90.0 |
| 高度 Z [mm] | 85.0 |
| 力矩 Mx max. [Nm] | 114.0 |
| 力矩 My max. [Nm] | 117.0 |
| 力矩 Mz max. [Nm] | 58.5 |
| 间隙 N（力矩负载） [mm] | 64.5 |
| 最大轴向力 Fz max。 [N] | 2150.0 |
| 带制动器型号 | 是 |
尺寸和最大载荷
尺寸和最大载荷
此处所示力和力矩均为单个荷载的最大值。如果同时施加一个以上力和/或力矩的应用可采用 TOOLBOX 工具计算。仅可采用 Toolbox 计算力Fy。
General notes about the series
Repeat accuracy
is defined as a distribution of the end positions for 100 consecutive cycles.
Travel times
are pure movement times of the slide or the base body. Valve switching times, hose filling times, or PLC reaction times are not a part of this and are to be considered when cycle times are calculated.
Stroke
is the maximum nominal stroke of the unit. It can be shortened on both sides by the shock absorbers.
Layout or control calculation
For configuration or control calculation of the units, we recommend to use our Toolbox software, which is available online. Verifying the sizing of the selected unit is absolutely necessary, as otherwise overloading may occur.
Ambient conditions
The modules are mainly designed for the use in clean ambient conditions. Please note that the life time of the modules can shorten if they are used in harsh ambient conditions, and that SCHUNK cannot assume liability in such cases. Please contact us for assistance.
Housing material
Aluminum alloy, anodized
Guidance
Backlash-free, pre-loaded cross roller guide
Actuation
pneumatic, with filtered compressed air as per ISO 8573-1:2010 [7:4:4].
Scope of delivery
Shock absorber and driver for proximity switch
Warranty
24 months
Service life characteristics
on request