DRL 25-W180-ASP
ID 314781
- Course verticale [axe Z]: 40 mm
- Angle de rotation: 180 °
- Poids de pièce: 3 kg
技术细节
| Angle de rotation [°] | 180 |
|---|---|
| Réglage angle de rotation par côte [°] | 2.0 |
| Course verticale [axe Z] [mm] | 40.0 |
| Course verticale linéaire [axe Z] [mm] | 20.0 |
| Réglage de course vertical par coté [axe Z] [mm] | 10.0 |
| Différence de hauteur max. entre les positions finales [mm] | 10.0 |
| Couple [Nm] | 3.7 |
| Lever force [N] | 321.0 |
| Force descente [N] | 298.0 |
| Répétabilité [axe Z] [mm] | ± 0.01 |
| Répétabilité [°] | 0.02 |
| Pression d'utilisation min. [bar] | 3.0 |
| Pression d'utilisation maximale [bar] | 5.0 |
| Pression d'utilisation nominale [bar] | 5.0 |
| Volume de la cylindre par cycle [cm³] | 200.0 |
| Température ambiante mini. [°C] | 5.0 |
| Température ambiant maxi. [°C] | 60.0 |
| Poids de pièce [kg] | 3.0 |
| Nombre de cycles max. autorisé par minute [1/min] | 63.0 |
| Poids [kg] | 5.0 |
| Version avec frein de maintien | Oui |
Charges max.
Temps de cycle
Temps de cycle
Charges max.
Aucune autre charge ne doit apparaître en plus de la charge résultant du maniement de l'assemblage.
Temps de cycle
- X 轴:
- Temps de cycle
- Y 轴:
- Moment d'inertie de masse
Temps de cycle
- X 轴:
- Temps de cycle
- Y 轴:
- Poids
General notes about the series
Repeat accuracy
Is defined as the spread of the target position after 100 consecutive positioning cycles.
Cycle times
The cycle times refer to a typical pick & place movement of the lift/turning unit. Please note that the actual cycle time is influenced by the hose length and/or hose diameter and valve switching or PLC response times.
Stroke
The stroke is the maximum nominal stroke per axis direction. It can be shortened for each side.
Ambient conditions
The modules are mainly designed for the use in clean ambient conditions. Please note that the life time of the modules can shorten if they are used in harsh ambient conditions, and that SCHUNK cannot assume liability in such cases. Please contact us for assistance.
Nominal load or mass moment of inertia
The values refer to the total load attached to the flange. Please note that the life time of the modules is shortened if the maximum values are exceeded and that SCHUNK cannot provide any warranty in such cases.