KLM 25-H042
ID 314011
- Course max.: 42 mm
Détails techniques
| Course [mm] | 42.0 |
|---|---|
| Sortir force [N] | 67.0 |
| Force de retrait [N] | 50.0 |
| Répétabilité [mm] | 0.02 |
| Diamètre du piston [mm] | 12.0 |
| Diamètre du tenon [mm] | 6.0 |
| Pression d'utilisation min. [bar] | 3.0 |
| Pression d'utilisation maximale [bar] | 8.0 |
| Pression d'utilisation nominale [bar] | 6.0 |
| Volume du cylindre/10 mm par course double [cm³] | 1.13 |
| Longueur totale [mm] | 169.0 |
| Indice de protection IP | 40 |
| Température ambiante mini. [°C] | 5.0 |
| Température ambiant maxi. [°C] | 60.0 |
| Catégorie salle blanche ISO 14644-1:1999 | 6 |
| Poids [kg] | 0.58 |
| Concept d'entraînement | Cylindres à tige de piston |
| Longueur X [mm] | 169.0 |
| Largeur Y [mm] | 45.0 |
| Hauteur Z [mm] | 32.0 |
| Moment Mx max. [Nm] | 1.9 |
| Moment My max. [Nm] | 9.5 |
| Moment Mz max. [Nm] | 9.5 |
| Distance N (pour la charge de moment) [mm] | 20.0 |
| Force axiale max. Fz max. [N] | 142.0 |
Dimensions et charges max.
Dimensions et charges max.
Les forces et les couples indiqués sont des valeurs maximales pour une charge individuelle. Si plusieurs forces et/ou couples se produisent simultanément, le cas d'application peut être calculé avec la Toolbox. La force Fy peut uniquement être calculée via la Toolbox.
General notes about the series
Repeat accuracy
is defined as a distribution of the end positions for 100 consecutive cycles.
Travel times
are pure movement times of the slide or the base body. Valve switching times, hose filling times, or PLC reaction times are not a part of this and are to be considered when cycle times are calculated.
Stroke
is the maximum nominal stroke of the unit. It can be shortened on both sides by the shock absorbers.
Layout or control calculation
For configuration or control calculation of the units, we recommend to use our Toolbox software, which is available online. Verifying the sizing of the selected unit is absolutely necessary, as otherwise overloading may occur.
Ambient conditions
The modules are mainly designed for the use in clean ambient conditions. Please note that the life time of the modules can shorten if they are used in harsh ambient conditions, and that SCHUNK cannot assume liability in such cases. Please contact us for assistance.
Housing material
Aluminum alloy, anodized
Guidance
Ball bushing guide
Actuation
pneumatic, with filtered compressed air as per ISO 8573-1:2010 [7:4:4].
Scope of delivery
Shock absorber and driver for proximity switch
Warranty
24 months
Service life characteristics
on request