PPU-E 30-H270-V100-03-D12
- horizontale slag [Y-as]: 270 mm
- verticale slag [Z-as]: 100 mm
- Max. nuttige last: 3 kg
Specifiche tecniche
| Aandrijfconcept | Lineaire, directe aandrijving |
|---|---|
| horizontale slag [Y-as] [mm] | 270.0 |
| verticale slag [Z-as] [mm] | 100.0 |
| Max. aandrijfkracht [Y-as] [N] | 400.0 |
| Nominale kracht [Y-as] [N] | 150.0 |
| Max. aandrijfkracht [Z-as] [N] | 550.0 |
| Nominale kracht [Z-as] [N] | 195.0 |
| Max. nuttige last [kg] | 3.0 |
| Herhalingsnauwkeurigheid [Y-as] [mm] | 0.01 |
| Herhalingsnauwkeurigheid [Z-as] [mm] | 0.01 |
| Max. stroom [Y-as] [A] | 8.0 |
| Stroom bij stilstand [Y-as] [A] | 1.8 |
| Max. stroom [Z-as] [A] | 12.0 |
| Stroom bij stilstand [Z-as] [A] | 3.2 |
| Min. omgevingstemperatuur [°C] | 10.0 |
| Max. omgevingstemperatuur [°C] | 40.0 |
| Interface slagmeetsysteem | Sin/Cos 1Vss |
| Geschikt voor C-as | MRD-S 12 |
| Aantal vloeistofdoorvoeren | 2.0 |
| Aantal elektrische aansluitingen krachtafneempunt | 1.0 |
| Speling N (voor momentbelasting) [mm] | 73.0 |
| Lengte X [mm] | 113.0 |
| Breedte Y [mm] | 335.0 |
| Hoogte Z [mm] | 745.2 |
| Moment Mx max. [Nm] | 24.0 |
| Moment My max. [Nm] | 6.0 |
| Moment Mz max. [Nm] | 50.0 |
| Kracht Fx max. [N] | 50.0 |
| Force Fy max. [N] | 400.0 |
| Kracht Fz max. [N] | 550.0 |
| Versie, voorzien van C-as | ja |
Dimensions and maximum loads
Cycle time
Dimensions and maximum loads
The indicated moments and forces are statical values and may appear simultaneously.
Cycle time
- Asse X:
- Mounting dimensions
- Asse Y:
- Cycle time
General notes about the series
Safety notes
Caution: Magnetic field! This particularly applies for persons with implanted medical devices, such as pacemakers, hearing aids, etc.
Repeat accuracy
defined as the spread of the target position after 100 consecutive positioning cycles under constant conditions.
Ambient conditions
The modules are mainly designed for the use in clean ambient conditions. Please note that the life time of the modules can shorten if they are used in harsh ambient conditions, and that SCHUNK cannot assume liability in such cases. Please contact us for assistance.
Layout or control calculation
Verifying the sizing of the selected unit is necessary, since otherwise overloading can result. Please contact us for assistance.
Payload
is the weight of the total weight which is attached to the cantilever arm. Please consider that service life will shorten if the maximum payload is exceeded. SCHUNK cannot assume any warranty for this.