DPG-plus 125-1-KVZ

General notes about the series

Finger length
is measured from the reference surface as the distance P in direction to the main axis. The maximum permissible finger length applies until the nominal operating pressure is achieved. With higher pressures, the finger length must be reduced proportionally to the nominal operating pressure.

Note – tightness
Please note that to achieve an IP 67 protection class, the gripper requires an additional hose for ventilation or a switchable air purge connection. For detailed information, please refer to the assembly and operating manual. Alternatively, a sinter filter (supplied) mounted on the air purge connection can prevent the penetration of dirt particles > 0.12 mm. However, this reduces the protection class to IP 54.

Gripping force
is the arithmetic sum of the individual force applied to each jaw at distance P (see illustration).

Repeat accuracy
is defined as a distribution of the end Position for 100 consecutive strokes.

Workpiece weight
is calculated for force-fit gripping with a coefficient of static friction of 0.1 and a safety factor of 2 against workpiece slippage at acceleration due to gravity g. For form-fit or capture gripping, there are significantly higher permissible workpiece weights.

Closing and opening times
are movement times of the base jaws only, without application-specific gripper fingers. Valve switching times, hose fill times, or PLC reaction times are not included, and are to be considered when cycle times are calculated.

Principio de funcionamiento
Cinemática de gancho en cuña

Material de la carcasa
Aleación de aluminio, anodizado duro

Material de las mordazas base
Acero

Accionamiento
Neumático, con aire comprimido filtrado según DIN ISO 8573-1: 7 4 4

Garantía
36 meses

Características de la vida útil
a petición

Material suministrado
Casquillos de centraje, O-rings para la conexión directa, instrucciones de montaje (el manual de instrucciones con declaración de incorporación está disponible en línea)

Mantenimiento de la fuerza de agarre
disponible en versiones con autoretención mecánica o una válvula antirretorno SDV-P